This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
asking_for_help [2015/08/24 19:40] mgstauff |
asking_for_help [2017/10/11 19:28] (current) mgstauff [--- If you're issue is not about the cluster ---] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== | + | ====== |
- | You can email the admins for help, but first, look at this checklist: | + | ====--- If you're issue is not about the cluster ---==== |
+ | |||
+ | For example | ||
+ | - Most network connection issues | ||
+ | - Software licenses for your desktop or laptop (for example Matlab or Office). Check with your PI and department, or use the contacts below. | ||
+ | |||
+ | ===Hospital faculty/ | ||
+ | If you're with UPHS (not School of Medicine), or if your issue is a UPHS networking or VPN issue, you probably need to [[accounts_and_vpn# | ||
+ | |||
+ | ===SAS or SEAS faculty/ | ||
+ | If you're __not__ with UPHS, or your issue is with PennNet or AirPennNet, check with ISC: | ||
+ | https:// | ||
+ | |||
+ | ====--- CfN Cluster Issues ---==== | ||
+ | You can email the CfN admins for help with the CfN cluster, but first, look at this checklist: | ||
- Are you running on chead instead of nodes? | - Are you running on chead instead of nodes? | ||
- | - Is it a memory issue? See the FAQ. | + | - Is it a memory issue? See the [[common_errors|Common Errors page]]. |
- Have you checked with your colleagues if they use the same or similar scripts or tools? | - Have you checked with your colleagues if they use the same or similar scripts or tools? | ||
- Is your disk quota full? Use '' | - Is your disk quota full? Use '' | ||
Line 14: | Line 28: | ||
* Are you using qlogin or qsub? | * Are you using qlogin or qsub? | ||
* Include the command you ran. | * Include the command you ran. | ||
- | * Include the output of the command and full error messages, or include the link to output files that show what's happened (i.e. for qsub, the .e and .o files). | + | * Include the output of the command and FULL error messages, or include the path to output files that show what's happened (i.e. for qsub, the .e and .o files). |
* What did you expect to happen? | * What did you expect to happen? | ||
* Has this worked before? If so, when? Did it work on the same data set or the exact same data? Does it work with other data sets or data point? | * Has this worked before? If so, when? Did it work on the same data set or the exact same data? Does it work with other data sets or data point? | ||
+ | * Email us at < |